Gamma 5kva / 48v PCU – Offgrid Solar rMPPT inverter
- [Battery Health For Longer Life] Gamma PCU feeds the battery installed to it a constant boost charging current until its voltage reaches 14.2V and the float current (which is very close to zero) then maintains this voltage above 13V. Thus reducing the float current ( flowing for the longest period during the entire process) to zero, ultimately resulting in much enhanced battery life keeping it fully charged simultaneously.
- [Extensive electronic protections] There are a number of protections that Gamma PCU ensures. It stops reverse current flow from battery to solar array, it provides load short circuit protection, it provides Battery/Panel reverse protection through DC fuse,Overload protection, Input low/High, Output Low/High.
- [Utilizes maximum power available from the panel] Gamma PCU senses the point of maximum power available in the panel and charges the battery with this maximum power. Therefore, the battery is always charged with maximum possible power at any given time. This is the feature that allows your device to work to its full capacity and thus deliver the best possible results.
- [LCD display] Gamma PCU is available with LCD, for better user interface. It shows Battery voltage, charging current, discharging current, Output voltage , Output frequency, Output load percentage, Input voltage, Input frequency, Solar voltage, Solar current & Solar Power. It has for switches to configure Operational mode, No load shut down, Grid charger, IT Load, Input source.
|Solar PCU Capacity||5KVA 48V|
|Input Voltage Range (min-max)||80-230 VDC|
|Maximum PV Power Recommended||5KW|
|Types of Charger||PWM with MPPT|
|Charge Controller Peak Efficiency||95%|
|Battery Low Buzzer||10.2V|
|Battery Low Cut||10.0V|
|Battery High Cut||15.5V|
|Battery Charging Voltage by SPV||14.5V|
|Battery Charging Current by SPV||18A|
|Battery Charging Voltage by GRID||14.2V|
|Battery Charging Current by GRID||10A|
|Grid Low Cut Voltage ( IT Load Disable/Enable)||120/175V|
|Grid High Cut Voltage ( IT Load Disable/Enable)||280/255V|
|Inverter Nominal Output Voltage||230VAC|
|Output Supply Phase||1 phase, 3 wire|
|Output Waveform||Sine wave|
|Nominal Frequency||50.0 HZ|
|Load Current||15.2 A|
|Inverter Peak Efficiency||>88%|
|Protections||Overload, Battery low, Battery high, Output low, Output high, Output Short Circuit, Overheat, Under Frequency, Over Frequency, Solar panel reverse|
|Display Parameters||Battery Voltage, Charging Current, Discharging Current* Solar Voltage, Solar Current, Instantaneous Power, Grid Voltage, I/P Frequency Output Voltage, Output Load% O/P Frequency Grid, Inverter & SPV Charger Status|
|Switches||Reset for System ON/OFF, up, Down, Back, Enter (for LCD Configuration)|
|Indications||System ON, Inv. ON, SPV Charging, Grid Charging, Battery Low/High, Overload, Overheat, Mains Low, Mains High, Under frequency, Over frequency, (IT Mode, Grid Charging, NLSD, Boost Charging, DG Mode)Enable/Disable*|
|Max Relative Humidity @25*C (non condensing)||95%|